Specifications

PROFILES 7 - 27
7.1.9 cdp
 config-profile config commands
Uses Cisco Discovery Protocol (CDP) on the device. CDP is a layer 2 protocol to discover information about neighboring
network devices
Supported in the following platforms:
• Access Points — AP300, AP621, AP622, AP650, AP6511, AP6521, AP6532, AP71XX, AP81XX
• Wireless Controllers — RFS4000, RFS6000, RFS7000, NX9000, NX9500
Syntax
cdp [holdtime|run|timer]
cdp [holdtime <10-1800>|run|timer <5-900>]
Parameters
• cdp [holdtime <10-1800>|run|timer <5-900>]
Examples
rfs7000-37FABE(config-profile-default-RFS7000)#cdp run
rfs7000-37FABE(config-profile-default-RFS7000)# holdtime 1000
rfs7000-37FABE(config-profile-default-RFS7000)# timer 900
rfs7000-37FABE(config-profile-default-RFS7000)#show context
profile RFS7000 default-RFS7000
bridge vlan 1
ip igmp snooping
no ip igmp snooping unknown-multicast-fwd
no ip igmp snooping mrouter learn pim-dvmrp
ip dhcp trust
holdtime 1000
timer 900
AP300 00-15-70-63-4F-86 adopt
service pm sys-restart
rfs7000-37FABE(config-profile-default-RFS7000)#
Related Commands
holdtime <10-1800> Specifies the holdtime after which transmitted packets are discarded
• <10-1800> – Specify a value from 10 - 1800 seconds.
run Enables CDP sniffing and transmit globally
timer <5-900> Specifies time between advertisements
• <5-900> – Specify a value from 5 - 900 seconds.
no Disables or reverts settings to their default