User guide

CONFIGURATION SECTION 3
SECTION 3, CONFIGURATION 3-17
Field Description
Connection Mode The AP supports two connection modes:
! Cable Modem (DHCP)
! Static Assigned
Select the appropriate connection method for
your ISP (Internet Service Provider).
Based on which connection type you select,
different areas are grayed out (become
inaccessible), leaving you only the appropriate
fields to fill in.
For details on each Connection Mode type,
refer to Section 2:Installation.
Connection
Status
Provides current information about the
connection status of the AP.
IP Address The AP’s IP Address used to connect to your
ISP or router. It is either automatically displayed
or manually entered from information provided
by the provider.
If DHCP is selected, this is the IP Address that
your AP is currently using to access the
Internet. If using Static Assigned, then you
would enter the IP Address here.
Subnet Mask Is either automatically displayed or manually
entered from information provided by your ISP.
Gateway IP Is either automatically displayed or manually
entered from information provided by your ISP.