Installation Manual VIP 1003
Caring for the Environment by Recycling WARNING When you see this symbol on a Motorola product, do not dispose of the product with residential or commercial waste. TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Recycling your Motorola Equipment Please do not dispose of this product with your residential or commercial waste.
Your VIP 1003 package Placement Enclosed material Do not cover The following material should be present in your package. Do not place anything on top of the set-top box, instead leave a free space of 20 cm above it for proper ventilation and cooling. IP set-top box AC adaptor Remote control with 2 AAA batteries Installation guide Ethernet cable SCART cable When using the remote control, point it to the IR-receiver in the center of the front panel.
VIP1003 overview INSTALLING Front panel of models without display Connecting to broadband Connect one end of the Ethernet cable to the connector marked ETHERNET on the rear panel of the set-top box and the other end to a hub or the Ethernet wall connector provided by your broadband operator. Connecting to the TV set Indicator LED:s • Green light - the set-top box is operational. • Flashing green light - the set-top box receives a signal from the remote control or a keyboard.
INSTALLING INSTALLING Optional: Connecting High definition Video Optional: Connecting to external audio If your TV set is HDTV compatible, you can connect the set-top box to the TV set using the HDMI connector instead of the SCART connector to receive and display HDTV, i.e. skip installation step and replace it with installation step . If you want to use an external source to play audio such as a stereo or home cinema equipment.
INSTALLING Navigating using the remote control Connecting to power The navigation buttons (the inner ring comprised by four arrow buttons and an OK button) are used to move around on Service portal pages and in menus, and to select the highlighted alternative. Connecting to power When all other cables are connected, connect the power cord to the power connector on the set-top box and to mains power.
Starting up When the set-top box is connected to the TV set, Ethernet and power, you will see an image similar to the one to the right on the TV screen. The set-top box is now connecting to the network and downloading the software needed. Please wait until the loading is finished. Five circles will indicate the download progress during the start up of the system. From the start, all circles are dark grey.