Specifications

Contents
vii
Configuring the Modem Using a Modemcap DC-70
Configuring the Modem Circuit Interface DC-72
Comparison of NextPort SPE and MICA Modem Commands DC-72
Configuring Cisco Integrated Modems Using Modem Attention Commands DC-75
Using Modem Dial Modifiers on Cisco MICA Modems DC-75
Changing Configurations Manually in Integrated Microcom Modems DC-76
Configuring Leased-Line Support for Analog Modems DC-77
Configuring Modem Pooling DC-81
Creating a Modem Pool DC-82
Verifying Modem Pool Configuration DC-83
Configuring Physical Partitioning DC-84
Creating a Physical Partition DC-85
Physical Partitioning with Dial-In and Dial-Out Scenario DC-87
Configuring Virtual Partitioning DC-89
Configuring Call Tracker DC-90
Verifying Call Tracker DC-91
Enabling Call Tracker DC-91
Configuring Polling of Link Statistics on MICA Modems DC-92
Configuring MICA In-Band Framing Mode Control Messages DC-93
Enabling Modem Polling DC-94
Setting Modem Poll Intervals DC-94
Setting Modem Poll Retry DC-94
Collecting Modem Statistics DC-94
Logging EIA/TIA Events DC-94
Configuring a Microcom Modem to Poll for Statistics DC-95
Troubleshooting Using a Back-to-Back Modem Test Procedure DC-95
Clearing a Direct Connect Session on a Microcom Modem DC-98
Displaying Local Disconnect Reasons DC-98
Removing Inoperable Modems DC-101
Busying Out a Modem Card DC-103
Monitoring Resources on Cisco High-End Access Servers DC-103
Enabling DS0 Busyout Traps DC-104
Enabling ISDN PRI Requested Channel Not Available Traps DC-105
Enabling Modem Health Traps DC-105
Enabling DS1 Loopback Traps DC-105
Verifying Enabled Traps DC-105
Troubleshooting the Traps DC-106
NAS Health Monitoring Example DC-106
Configuration Examples for Modem Management DC-109
NextPort Modem Log Example DC-109