Specifications

Configuring Wholesale Dial Performance Optimization
Verifying Configuration of TCP Clear Performance Optimization
DC-760
Cisco IOS Dial Technologies Configuration Guide
Verifying Configuration of TCP Clear Performance Optimization
To check for correct configuration, use the show line command. In the following example, Telnet
faststream is enabled under “Capabilities”.
Router# show line 1/4/00
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
* 1/4/00 Digital modem - inout - - - 1 0 0/0 -
Line 1/4/00, Location: "", Type: ""
Length: 24 lines, Width: 80 columns
Status: PSI Enabled, Ready, Connected, Active, No Exit Banner
Modem Detected
Capabilities: Hardware Flowcontrol In, Hardware Flowcontrol Out
Modem Callout, Modem RI is CD, Line usable as async interface
Hangup on Last Close, Modem Autoconfigure, Telnet Faststream
Modem state: Ready
Modem hardware state: CTS DSR DTR RTS
modem=1/4/00, vdev_state(0x00000000)=CSM_OC_STATE, bchan_num=(T1 1/2/0:7:20)
vdev_status(0x00000001): VDEV_STATUS_ACTIVE_CALL.
Group codes: 0, Modem Configured
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
never never none not set
Idle Session Disconnect Warning
never
Login-sequence User Response
00:00:30
Autoselect Initial Wait
not set
Modem type is 9600.
Session limit is not set.
Time since activation: never
Editing is enabled.
History is enabled, history size is 10.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed transports are telnet. Preferred is lat.
Automatically execute command "telnet 10.100.254.254 2145 /stream"
No output characters are padded
Command Purpose
Step 1
Router(config)# line 1/3/00 1/11/143
Selects the lines to be configured and begins line
configuration mode.
Step 2
Router(config-line)# autocommand
telnet-faststream
Enables the TCP Clear performance optimization on the
selected lines.