Specifications

Configuring Resource Pool Management
Configuration Examples for RPM
DC-755
Cisco IOS Dial Technologies Configuration Guide
resource-pool profile discriminator deny_DNIS
call-type digital
dnis group bye-bye
!
resource-pool profile service gold
modem min-speed 33200 max-speed 56000 modulation v90
resource-pool profile service silver
modem min-speed 19200 max-speed 33200 modulation v34
!
resource-pool aaa protocol local
!
template acme_direct
peer default ip address pool tahoe
ppp authentication chap isdn-users
ppp multilink
!
dialer dnis group ACME_dnis_numbers
number 301001
dialer dnis group bye-bye
number 301005
VPDN Configuration Example
Adding the following commands to those listed in the section “Standard Configuration for RPM
Example” earlier in this chapter allows you to use VPDN by setting up a VPDN profile and a VPDN
group:
Note If the limits imposed by the VPDN profile are not required, do not configure the VPDN profile.
Replace the vpdn profile ACME_VPDN command under the customer profile ACME with the vpdn
group outgoing-2 command.
resource-pool profile vpdn ACME_VPDN
limit base-size 6
limit overflow-size 0
vpdn group outgoing-2
!
resource-pool profile customer ACME
limit base-size 30
limit overflow-size 10
resource isdn-ports digital
resource MICA-modems speech service gold
dnis group ACME_dnis_numbers
!
vpdn profile ACME_VPDN
!
vpdn enable
!
vpdn-group outgoing-2
request dialin
protocol 12f
dnis ACME_dnis_numbers
local name HQ-NAS
initiate-to ip 172.16.1.9
multilink bundle 1
multilink link 2
!
dialer dnis group ACME_dnis_numbers
number 301001