Specifications

Configuring Resource Pool Management
How to Configure RPM
DC-736
Cisco IOS Dial Technologies Configuration Guide
Configuring Switched 56 over CT1 and RBS
To configure switched 56 over CT1 and RBS, use the following commands beginning in global
configuration mode. Perform this task on the Cisco AS5200 and Cisco AS5300 access servers only.
To verify switched 56 over CT1, use the show dialer dnis command as follows:
Router# show dialer dnis group
List of DNIS Groups:
default
mdm_grp1
Router# show dialer dnis group mdm_grp1
Called Number:2001
0 total connections
0 peak connections
0 calltype mismatches
Called Number:2002
0 total connections
0 peak connections
0 calltype mismatches
Called Number:2003
0 total connections
0 peak connections
0 calltype mismatches
Called Number:2004
0 total connections
0 peak connections
0 calltype mismatches
.
.
.
Command Purpose
Step 1
Router(config)# controller t1 number
Specifies a controller and begins controller
configuration mode.
Step 2
Router(config-controller)# cas-group 0 timeslots
1-24 type e&m-fgb {dtmf | mf} {dnis}
Creates a CAS group and assigns time slots.
Step 3
Router(config-controller)# framing {sf | esf}
Specifies framing.
Step 4
Router(config-controller)# linecode {ami | b8zs}
Enters the line code.
Step 5
Router(config-controller)# exit
Returns to global configuration mode.
Step 6
Router(config)# dialer dnis group name
Creates a dialer called group.
Step 7
Router(config-called-group)# call-type cas digital
Assigns a call type as digital (switch 56).
Step 8
Router(config-called-group)# exit
Returns to global configuration mode.
Step 9
Router(config)# interface serial number:number
Router(config-if)#
Specifies the logical serial interface, which was
dynamically created when the cas-group command was
issued.
This command also enters interface configuration mode,
where you configure the core protocol characteristics
for the serial interface.