Specifications

Configuring Resource Pool Management
How to Configure RPM
DC-728
Cisco IOS Dial Technologies Configuration Guide
The backup customer profile can contain all of the elements defined in a standard customer profile,
including base size or overflow parameters. However, when the connection between the Cisco NAS and
Cisco RPMS is unavailable, session counting and session limits are not applied to incoming calls. Also,
after the connection is reestablished, there is no synchronization of call counters between the Cisco NAS
and Cisco RPMS.
Configuring Customer Profiles for Using DoVBS
To configure customer profiles for using DoVBS, use the following commands beginning in global
configuration command mode:
To support ISDN DoVBS, use a DNIS group and a configured customer profile to direct the speech call
to the appropriate digital resource. The DNIS group assigned to the customer profile should have a call
type of speech. The resource group assigned to this customer profile will be digital resources and also
have a call type of speech, so the call will terminate on an HDLC controller rather than a modem.
See the section “Customer Profile Configuration for DoVBS Example” at the end of this chapter for a
configuration example.
Configuring a Customer Profile Template
Customer profile templates provide a way to keep each unique situation for a customer separate for both
security and accountability. This is an optional configuration task.
To configure a template and place it in a customer profile, ensure that all basic configuration tasks and
the RPM configuration tasks have been completed and verified before attempting to configure the
customer profile templates.
To add PPP configurations to a customer profile, create a customer profile template. Once you create the
template and associate it with a customer profile by using the source template command, it is integrated
into the customer profile.
Command Purpose
Step 1
Router(config)# resource-pool profile customer
name
Assigns a name to a customer profile.
Step 2
Router(config-customer-pro)# dnis group name
Assigns a DNIS group to the customer profile. DNIS
numbers are assigned as shown in the previous section.
Step 3
Router(config)# limit base-size { number | all}
Specifies the VPDN base size usage limit.
Step 4
Router(config)# limit overflow-size { number | all}
Specifies the VPDN overflow size usage limit.
Step 5
Router(config-customer-pro)# resource name {digital
| speech | v110 | v120} [service
name ]
Specifies resource names to use within the customer
profile.