Specifications

Configuring Resource Pool Management
How to Configure RPM
DC-726
Cisco IOS Dial Technologies Configuration Guide
Configuring Resource Groups
To configure resource groups, use the following commands beginning in global configuration mode:
For external Cisco RPMS environments, configure resource groups on the NAS before defining them on
external RPMS servers.
For standalone NAS environments, first configure resource groups before using them in customer
profiles.
Resource groups can apply to multiple customer profiles.
Note You can separate physical resources into groups. However, do not put heterogeneous resources in the
same group. Do not put MICA technologies modems in the same group as Microcom modems. Do
not put modems and HDLC controllers in the same resource group. Do not configure the port and
limit command parameters in the same resource group.
Configuring Service Profiles
To configure service profiles, use the following commands beginning in global configuration mode:
Service profiles are used to configure modem service parameters for Nextport and MICA technologies
modems, and support speech, digital, V.110, and V.120 call types. Error-correction and compression are
hidden parameters that may be included in a service profile.
Command Purpose
Step 1
Router(config)# resource-pool group resource name
Creates a resource group and assign it a name of up to
23 characters.
Step 2
Router(config-resource-group)# range {port
{
slot/port slot/port }} | {limit number }
Associates a range of modems or other physical
resources with this resource group:
• For port-based resources, use the physical locations
of the resources.
• For non-port-based resources, use a single integer
limit. Specify the maximum number of
simultaneous connections supported by the
resource group. Up to 192 connections may be
supported, depending on the hardware
configuration of the access server.
Command Purpose
Step 1
Router(config)# resource-pool profile service name
Creates a service profile and assign it a name of up to 23
characters.
Step 2
Router(config-service-profil)# modem min-speed
{
speed | any} max-speed { speed | any [modulation
value ]}
Specifies the desired modem parameter values. The
range for min-speed and max-speed is 300 to 56000
bits per second.