Specifications

Configuring Resource Pool Management
How to Configure RPM
DC-723
Cisco IOS Dial Technologies Configuration Guide
Note If you have an RPMS, you need not define VPDN groups/profiles, customer profiles, or DNIS groups
on the NAS; you need only define resource groups. Configure the remaining items by using the
RPMS system.
Configuring DNIS Groups
This configuration task is optional.
To configure DNIS groups, use the following commands beginning in global configuration mode:
For default DNIS service, no DNIS group configuration is required. The following characteristics and
restrictions apply to DNIS group configuration:
• Each DNIS group/call-type combination can apply to only one customer profile.
• You can use up to four default DNIS groups (one for each call type).
• You must statically configure CAS call types.
• You can use x, X or . as wildcards within each DNIS number.
Command Purpose
Step 1
Router(config)# dialer dnis group
dnis-group-name
Creates a DNIS group. The name you specify in this step
must match the name entered when configuring the
customer profile.
Step 2
Router(config-called-group)# call-type cas
{digital | speech}
Statically sets the call-type override for incoming CAS
calls.
Step 3
Router(config-called-group)# number number
Enters DNIS numbers to be used in the customer profile.
(Wildcards can be used.)