Specifications

Configuring per-User Configuration
Monitoring and Debugging Per-User Configuration Settings
DC-688
Cisco IOS Dial Technologies Configuration Guide
Monitoring and Debugging Per-User Configuration Settings
Per-user configuration information exists on AAA servers only and is configured there, as described in
the “How to Configure a AAA Server for Per-User Configuration” section.
For more information about configuring an application that can tie AAA per-user configuration
information to generic interface and router configuration, see the chapter “Configuring Virtual Profiles”
in this publication. Virtual profiles are required for combining per-user configuration information and
generic interface and router configuration information to create virtual access interfaces for individual
ISDN B channels.
However, you can monitor and debug the per-user configuration settings on the router or access server
that are set from an AAA server. Table 40 indicates some of the commands to use for each attribute.
Configuration Examples for Per-User Configuration
The following sections provide two comprehensive examples:
• TACACS+ Freeware Examples
• RADIUS Examples
These examples show router or access server configuration and AV pair configuration on an AAA server.
TACACS+ Freeware Examples
This section provides the TACACS+ freeware versions of the following examples:
• IP Access Lists and Static Routes Using Virtual Profiles over ISDN BRI
• IPX Per-User SAP Filters Using IPXWAN and Virtual Profiles by a Synchronous Interface
Table 40 Monitoring and Debugging Per-User Configuration Commands
Attribute show Commands debug Commands
inacl#
outacl#
show ip access-list
show ip interface interface
show ipx access-list
show ipx interface
debug aaa authorization
debug aaa per-user
rte-fltr-in#
rte-fltr-out#
show ip access-list
show ip protocols
debug aaa authorization
debug aaa per-user
route# show ip route
show ipx route
debug aaa authorization
debug aaa per-user
sap# show ipx servers debug aaa authorization
debug aaa per-user
sap-fltr-in#
sap-fltr-out#
show ipx access-list
show ipx interface
debug aaa authorization
debug aaa per-user
pool-def#
pool-timeout
show ip local pool [name]—