Specifications

Configuring and Managing Cisco Access Servers and Dial Shelves
Upgrading and Configuring SPE Firmware
DC-136
Cisco IOS Dial Technologies Configuration Guide
Verifying SPE Line and Port Configuration
To verify your SPE line configuration, enter the show spe command to display a summary for all the
lines and ports:
Step 1 Enter the show spe command to display a summary for all the lines and ports:
Router# show spe
Step 2 Enter the show line command to display a summary for a single line.
AS5400
Router# show line 1/1
AS5800
Router# show line 1/2/10
Note If you are having trouble, make sure that you have turned on the protocols for If you are
having trouble, make sure that you have turned on the protocols for connecting to the lines
(transport input all) and that your access server is configured for incoming and outgoing
calls (modem inout).
Configuring SPE Performance Statistics
Depending on the configuration, call record is displayed on the console, or the syslog, or on both. The
log contains raw data in binary form, which must be viewed using the show commands listed in the
section “Monitoring SPE Performance Statistics.” You can configure some aspects of history events by
using one of the following commands in global configuration mode:
Command Purpose
Router(config)# spe call-record modem max-userid
Requests the access server to generate a modem call record after
a call is terminated. To disable this function, use the no form of
this command.
Router(config)# spe log-size number
Sets the maximum size of the history event queue log entry for
each port. The default is 50 events per port.