Specifications

Configuring and Managing Cisco Access Servers and Dial Shelves
Upgrading and Configuring SPE Firmware
DC-132
Cisco IOS Dial Technologies Configuration Guide
Note The copy ios-bundled command is not necessary with UPCs or NextPort DFCs. By default, the
version of SPE firmware bundled with the Cisco IOS software release transfers to all SPEs not
specifically configured for a different SPE firmware file.
Disabling SPEs
To disable specific SPEs in the Cisco AS5400 NextPort DFCs or Cisco AS5800 UPCs, use the following
commands starting in global configuration mode:
Step 5
Router(config-spe)# firmware location filename
Specifies the SPE firmware file in Flash memory to use for
the selected SPEs. Allows you to upgrade firmware for
SPEs after the new SPE firmware image is copied to your
Flash memory.
Enter the no firmware location command to revert back to
the default Cisco IOS bundled SPE firmware.
Step 6
Router(config-spe)# exit
Exits SPE configuration mode.
Step 7
Router# exit
Exits global configuration mode.
Step 8
Router# copy running-config startup-config
Saves your changes.
Command Purpose
Command Purpose
Step 1 Cisco AS5400 Series Routers
Router(config)# spe slot/spe
or
Router(config)# spe slot/spe slot/spe
Cisco AS5800 Series Routers
Router(config)# spe shelf/slot/spe
or
Router(config)# spe shelf/slot/spe
shelf/slot/spe
Enters SPE configuration mode. You can also configure
SPEs specifying the first and last SPE in a range.