Specifications

Configuring and Managing Cisco Access Servers and Dial Shelves
Upgrading and Configuring SPE Firmware
DC-127
Cisco IOS Dial Technologies Configuration Guide
Firmware Configuration Task List
To complete firmware configuration once you have downloaded the SPE firmware, perform the tasks in
the following sections:
• Specifying a Country Name
• Configuring Dial Split Shelves (AS5800 Only)
• Configuring SPEs to Use an Upgraded Firmware File
• Disabling SPEs
• Rebooting SPEs
• Configuring Lines
• Configuring Ports
• Verifying SPE Line and Port Configuration
• Configuring SPE Performance Statistics
• Clearing Log Events
• Troubleshooting SPEs
• Monitoring SPE Performance Statistics
Note The following procedure can be used for either a Cisco AS5400 or AS5800 access server.
Downloading SPE Firmware from the Cisco.com FTP Server to a Local TFTP
Server
Note You must be a registered Cisco user to log in to the Cisco Software Center.
You can download software from the Cisco Systems Cisco.com FTP server using an Internet browser or
using an FTP application. Both procedures are described.
Using an Internet Browser
Step 1 Launch an Internet browser.
Step 2 Bring up the Cisco Software Center home page at the following URL (this is subject to change without
notice):
http://www.cisco.com/kobayashi/sw-center/
Step 3 Click Access Software (under Cisco Software Products) to open the Access Software window.
Step 4 Click Cisco AS5400 Series or Cisco AS5800 Series software.
Step 5 Click the SPE firmware you want and download it to your workstation or PC. For example, to download
SPE firmware for the universal access server, click Download Universal Images.
Step 6 Click the SPE firmware file you want to download, and then follow the remaining download instructions.
If you are downloading the SPE firmware file to a PC, make sure that you download the file to the
c:/tftpboot directory; otherwise, the download process does not work.