Specifications

Configuring and Managing Integrated Modems
Configuration Examples for Modem Management
DC-109
Cisco IOS Dial Technologies Configuration Guide
Configuration Examples for Modem Management
This section provides the following examples:
• NextPort Modem Log Example
• Modem Performance Summary Example
• Modem AT-Mode Example
• Connection Speed Performance Verification Example
For additional information and examples about the commands in this chapter, refer to the Cisco IOS Dial
Technologies Command Reference.
NextPort Modem Log Example
The following is partial sample output for the Cisco AS5400 with the NextPort Distributed forwarding
Card (DFC). This example shows the port history event log for slot 5, port 47:
Router# show port modem log 5/47
Port 5/47 Events Log
Service type: DATA_FAX_MODEM
Service mode: DATA_FAX_MODEM
Session State: IDLE
00:02:23: incoming called number: 35160
Service type: DATA_FAX_MODEM
Service mode: DATA_FAX_MODEM
Session State: IDLE
Service type: DATA_FAX_MODEM
Service mode: DATA_FAX_MODEM
Session State: ACTIVE
00:02:23: Modem State event:
State: Connect
00:02:16: Modem State event:
State: Link
00:02:13: Modem State event:
State: Train Up
00:02:05: Modem State event:
State: EC Negotiating
00:02:05: Modem State event:
State: Steady
00:02:05: Modem Static event:
Connect Protocol : LAP-M
Compression : V.42bis
Connected Standard : V.34+
TX,RX Symbol Rate : 3429, 3429
TX,RX Carrier Frequency : 1959, 1959
TX,RX Trellis Coding : 16/16
Frequency Offset : 0 Hz
Round Trip Delay : 0 msecs
TX,RX Bit Rate : 33600, 33600
Robbed Bit Signalling (RBS) pattern : 0
Digital Pad : None
Digital Pad Compensation : None
4 bytes of link info not formatted : 0x00 0x00 0x00 0x00 0x00
00:02:06:Modem Dynamic event:
Sq Value : 5
Signal Noise Ratio : 40 dB
Receive Level : -12 dBm
Phase Jitter Frequency : 0 Hz