Specifications

Configuring and Managing Integrated Modems
Managing Modems
DC-92
Cisco IOS Dial Technologies Configuration Guide
calltracker call-record terse
calltracker history max-size 50
calltracker history retain-mins 5000
!
snmp-server engineID local 0012345
snmp-server community public RW
snmp-server community private RW
snmp-server community wxyz123 view v1default RO
snmp-server trap-source FastEthernet0
snmp-server packetsize 17940
snmp-server queue-length 200
snmp-server location SanJose
snmp-server contact Bob
snmp-server enable traps snmp
snmp-server enable traps calltracker
snmp-server enable traps isdn call-information
snmp-server enable traps hsrp
snmp-server enable traps config
snmp-server enable traps entity
snmp-server enable traps envmon
snmp-server enable traps bgp
snmp-server enable traps ipmulticast-heartbeat
snmp-server enable traps rsvp
snmp-server enable traps frame-relay
snmp-server enable traps rtr
snmp-server enable traps syslog
snmp-server enable traps dlsw
snmp-server enable traps dial
snmp-server enable traps dsp card-status
snmp-server enable traps voice poor-qov
snmp-server host 10.255.255.255 wxyz123
snmp-server host 10.0.0.0 xxxyyy calltracker
!
radius-server host 172.16.0.0 auth-port 1645 acct-port 1646 non-standard
radius-server key xyz
!
Configuring Polling of Link Statistics on MICA Modems
The status and diagnostic data that is routinely collected from MICA modems is expanded to include
new link statistics for active calls, such as the attempted transmit and receive rates, the maximum and
minimum transmit and receive rates, and locally and remotely issued retrains and speedshift counters.
This connection data is polled from the modem at user-defined intervals and passed to Call Tracker.
To poll modem link statistics, use the following command in global configuration mode:
Note The modem link-info poll time command consumes a substantial amount of memory, approximately
500 bytes for each MICA modem call. Use this command only if you require the specific data that it
collects; for instance, if you have enabled Call Tracker on your access server.
Command Purpose
Router(config)# modem link-info poll
time
seconds
Sets the polling interval at which link statistics for active
calls are retrieved from the modem.