Specifications

4-6 800 MHz System Planner R4-11-4G
FIXED NETWORK EQUIPMENT
Radio Network Controller 3000
A/B SWITCH
EXPANDABLE BANK
TDN1084 A/B switch bank expansion that supports up to 16
channels. Maximum of three per RNC configuration.
Required to be ordered with TDN1083 for systems
needing more than 16 channels. Includes a second
power supply module installed in the first switch bank
for additional channel support.
Multiple switch banks are not to exceed four banks, are
daisy-chained together using a standard straight
through cable with a 9-pin male connector. The host
connection to the switch requires a standard RS-232
cable with a 25-pin male connector.
CABLE 5FT LEASE LINE
MODEM
TDN1089 Cable used for the connection of A/B switch to the
modem bank.
CABLE 15FT LEASE LINE
MODEM
TDN1090 Cable used for the connection of A/B switch to the
modem bank.
CABLE 30FT LEASE LINE
MODEM
TDN1091 Cable used for the connection of A/B switch to the
modem bank.
SEVEN FOOT RACK TRN7342 A 7-foot rack to permit the RNC3000 along with modem
card cages and modem rack adapters to be collocated.
Used in place of a cabinet at the customer’s option.
SEVEN AND A HALF
FOOT RACK
TRN7343 A 7-1/2 foot rack to permit the RNC3000 along with
modem card cages and modem rack adapters to be
collocated. Used in place of a cabinet at the customer’s
option.
EIGHT FOOT RACK TRN7344 An 8-foot rack to permit the RNC3000 along with
modem card cages and modem rack adapters to be
collocated. Used in place of a cabinet at the customer’s
option.
HDW RACKMNT
QUANTAR STDALONE
TTN5028A A set of two mounting extensions with eight screws.
Measures four-and-one-half-inches wide, eight and
three-quarters-inches long, and 11/16-inches deep in
size.
It is used with the 7, 7-1/2, and 8-foot open racks to
distribute the weight of the RNC3000 more evenly.
Order two sets of these per each RNC unit. Used with
the TDN8799 Rack Card Cage shown on the preceding
page. Additional holes could be required.
sr001 rackmount with 2
telco 16 RJ45
DQTORK118556 19-inch rack mounted unit with 16 RJ-45 (16 positions)
jacks mounted in the front of the panel and 2 Telco
50-pin female jacks mounted in the back. Two
ZA00096AA (10 foot) cables OR two ZA00096AB (30
foot) cables are required.
ENH: CARRIER SDCP
COMSHARE 3000
ZA00079AA Shared Diagnostic Control Panel (SDCP) that is
mounted below the card cage.
Table 4-5. Hardware Accessories for RNC3000 (Continued)
COF DESCRIPTION
ACCESS
NUMBER
DESCRIPTION