Specifications

4-42 800 MHz System Planner R4-11-4G
NETWORK EQUIPMENT
Accessories for GPS
4.5.1 Accessories for GPS
Table 4-36 lists the accessories for the GPS.
4.6 Network Equipment
Table 4-37 lists the networking equipment, describing the hubs, switches and
cables.
Table 4-36. Hardware Accessories for GPS
COF DESCRIPTION
ACCESS.
NUMBER
DESCRIPTION
TRMBLE FOG, BLKHD
ANTENNA CBL
CDN6277 Adds an 18-foot antenna cable that links the antenna to the
receiver processing unit.
TRMBLE PLCR GPS 400
INTR CBL
CDN6278 Adds a DB-9 M-F 3-foot cable used to connect the GPS to
the computer used for programming or testing.
CABLE, 20 FT DB9 M-F FKN4367 Adds a DB-9 M-F 20-foot cable added to the F5200 to
connect it to the GPS receiver.
CABLE, 10FT DB9 M-F FKN4369 Adds a DB-9 M-F 10-foot cable added to the F5200 to
connect it to the GPS receiver.
CABLE, TRIMBLE GPS
DB9, 20FT
FKN4548 Adds a DB-9 M-F 20-foot cable used to connect the Trimble
Placer GPS receiver to the VRMs.
FUSE KIT FOR GRN &
ORG LEADS
HLN4952A Adds a fuse kit that consists of two complete in-line fuse
holders and fuses with hardware. No installation hardware or
wire is included.
Table 4-37. Cables, Hubs, and Switches
COF DESCRIPTION
ACCESS.
NUMBER
DESCRIPTION
12 PORT NON-SNMP
HUB
CDN1643 A hub equipped with 12 RJ-45 10BaseT ports, hub for use in
shared ethernet networks without FullVision INM, and is non -
SNMP. It has an extra port for a backbone connection, if
necessary. The hubs are rack mountable and comes with a
mounting kit.
24 PORT NON-SNMP
HUB
CDN1644 A hub equipped with 24 RJ-45 10BaseT ports for use in
shared ethernet networks without FullVision INM and is non-
SNMP. It has an extra port for a backbone connection, if
necessary. The hubs are rack mountable and comes with a
mounting kit.
QTY 4 - 7 FT 10BASE-T
ETHERNET CBL
CDN6330 Adds four 7-foot, 10BaseT ethernet cables with RJ-45 to
RJ 45 connectors on both ends. Two cables are required per
hub. One connects to the ethernet. The other connects to the
network.
QTY 1 - 14 FT 10BASE-T
ETHERNET CB
CDN6331 Adds a 14-foot, 10BaseT ethernet cable, with RJ-45 to RJ-45
connectors on both ends. Two cables are required per hub.
One connects to the ethernet, and the other connects to the
network.