Specifications

<C#>
Introduction
<C#>-2 V.3229 / V.3229L
<Re
f
erence>
Installation
Strap Inspection
Several hardware straps on the printed circuit board
may require changing prior to installation. Refer to
Strap Option Selection at the front of Chapter 3 for
information.
ELECTRICAL
INSTALLATION
The rear panel (Figure 2-1) houses connectors for the
DTE cable and telephone lines.
AC Power
Connection
Power is supplied through a 6-foot line cord with a
grounded 3-wire plug. If common ground is avail-
able through the third prong of the plug, a separate
ground wire is not required. If the modem has a 110/
220V switch, select the appropriate voltage. If 220
Volt operation is selected, install the supplied 1/8
Amp fuse before connecting power to the modem.
DC Power
Input Option
Caution: To protect the dc to dc converter from
damage, ensure the positive and negative leads are
properly connected.
If the modem is equipped for dc power input, connect
12 to 60 Vdc power to the terminal block attached to
the modem back panel. A chassis ground connection
is also supplied on the terminal block.