Specifications

V.3229 / V.3229L <C#>-7
7
V.25 bis Autodiale
r
Incoming ring detected.
Program Number
Command
PRN a; nn...n
The program number command is PRN followed by
the one digit decimal address a and the number to
be stored nn...n. Each address can store up to 32
dial parameters. Ignored characters in the dial num-
ber are not stored. Nine stored numbers are available
at addresses 1-9.
Responses:
Same as for the CRN command.
Intermediate
Call Progress
Responses
The following responses are given only if enabled.
Refer to the OPTIONS section later in this chapter.
CNX<sp>@nnnnnBPS<sp>ccccc - where nnnnn is
the line speed and ccccc is an identifier with a max-
imum of five characters, such as V.29. This connect
response appears after handshake completed, but
before DSR is activated. This response is required if
the intermediate call progress option is enabled.
DialStoredNumber
CRS a
The command for dialing a stored number is CRS
followed by the one digit address a for the stored
number to be dialed.
Responses:
Same as for the CRN command plus