Specifications

<C#>-56 V.3229 / V.3229L
5
A
synchronous Operating Commands
x and y indicate passwords
PROTOCOL
COMMANDS
These commands enable or control the various data
compression, flow control, and error correction op-
tions of the modem. Table 5-3 illustrates mode and
condition availabilities.
Table 5-3
Operating Modes and Features Available
Serial Port (DTE)
bps Adjust
\J
The AT\J command allows DCE and DTE
to operate at different speeds. The AT\J1 command
forces serial port (DTE) speed to follow data link
speed in any mode.
If the modem is in direct mode (\J1) and a DCE link
is established at a speed other than that of the original
DTE autobaud speed, the modem will issue the
Table 47:
Operating
Mode
Error
Correction
Data
Compres-
sion
Flow
Control
Data Constant
Speed
Interface
Normal Disabled Not applica-
ble
Allowed Buffered On or off
Direct Disabled Not applica-
ble
Not
applica-
ble
Not
buffered
DTE=DCE
(slaved)
Reliable
(MNP and
LAPM)
Enabled On or off Allowed Buffered On or off
Auto-reli-
able
(MNP and
LAPM)
Enabled On or off Allowed Buffered On or off