Specifications

<C#>-54 V.3229 / V.3229L
5
A
synchronous Operating Commands
SECURITY
COMMANDS
The following AT commands operate security.
Refer to Chapter 4 for information on operating with
security.
Set Password
$S=x
Entering AT$S=x sets an empty password location
to x. This command only applies when no password
or only one is stored in memory. It can not be used
to change a password.
Changing a
Password
$C=x, y
AT$C=x, y changes either password where x rep-
resents the old password and y is the new one.
Deleting a
Password
$C=x,-
AT$C=x,- deletes password x from memory. Se-
curity is automatically disabled if the last password
is deleted.
Security
Reset
$DR
This command resets security to its initial state (off
with no passwords stored). The option is not avail-
able in remote configuration.
Disabling
Security