Specifications

User Preferences 6 - 17
Picklist Mode
Parameter # F0h 92h
Picklist mode enables the imager to decode only bar codes aligned under the center of the laser aiming
pattern. Select one of the following picklist modes:
• Disabled Always - Picklist mode is always disabled.
• Enabled Always - Picklist mode is always enabled.
Decode Session Timeout
Parameter # 88h
This parameter sets the maximum time decode processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
To set a Decode Session Timeout, scan the bar code below. Next, scan two numeric bar codes from Appendix
D, Numeric Bar Codes that correspond to the desired on time. Provide a leading zero for single digit numbers.
For example, to set a Decode Session Timeout of 0.5 seconds, scan the bar code below, then scan the 0 and
5 bar codes. To correct an error or change the selection, scan Cancel on page D-3.
NOTE With Picklist Mode enabled, the decode aiming pattern turns on even when the Decode Aiming Pattern on
page 7-6 is disabled.
Picklist mode does not apply to OCR reading.
*Disabled Always
(00h)
Enabled Always
(02h)
Decode Session Timeout