Specifications

User Preferences 6 - 3
User Preferences Parameter Defaults
Table 6-1 lists defaults for user preferences parameters. To change any parameter value, scan the appropriate
bar code(s) provided in the User Preferences section beginning on page 6-5.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 6-1 User Preferences Default Table
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter Restore Defaults 6-5
Parameter Scanning ECh Enable 6-6
User Parameter Pass Through F1h 71h Disable 6-7
Beep After Good Decode 38h Enable 6-8
Beeper Tone 91h Medium 6-9
Beeper Volume 8Ch High 6-10
Suppress Power-up Beeps F1h D1h Do not suppress 6-10
Trigger Mode 8Ah Presentation 6-11
Motion Enhancement for Presentation Mode F1h A6h Disable 6-12
Motion Enhancement Performance Setting F1h 8Ah Standard 6-12
Time Delay to Motion Enhancement Sleep Mode F1h 96h 1 Minute 6-13
Power Mode 80h Low Power 6-15
Time Delay to Low Power Mode 92h 1.0 Sec 6-15
Picklist Mode F0h 92h Disabled Always 6-17
Decode Session Timeout 88h 9.9 Sec 6-17
Timeout Between Decodes, Same Symbol 89h 0.6 Sec 6-18
Continuous Bar Code Read F1h 89h Disable 6-18
Mirrored Image F1h 70h Disable 6-19
Mobile Phone/Display Mode F1h CCh Disable 6-19
Validate Concatenated Parameter Bar Codes F1h B4h Disable 6-20
PDF Prioritization F1h CFh Disable 6-21