Specifications

APPENDIX A STANDARD DEFAULT
PARAMETERS
Default Parameters
Table A-1 Standard Default Parameters Table
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter Restore Defaults 6-5
Parameter Scanning ECh Enable 6-6
User Parameter Pass Through F1h 71h Disable 6-7
Beep After Good Decode 38h Enable 6-8
Beeper Tone 91h Medium 6-9
Beeper Volume 8Ch High 6-10
Suppress Power-up Beeps F1h D1h Do not suppress 6-10
Trigger Modes 8Ah Presentation 6-11
Motion Enhancement for Presentation Mode F1h A6h Disable 6-12
Motion Enhancement Performance Setting F1h 8Ah Standard 6-12
Time Delay to Motion Enhancement Sleep Mode F1h 96h 1 Minute 6-13
Power Mode 80h Low Power 6-15
Time Delay to Low Power Mode 92h 1.0 Sec 6-15
Picklist Mode F0h 92h Disabled Always 6-17
Decode Session Timeout 88h 9.9 Sec 6-17
1
User selection is required to configure this interface and this is the most common selection.