Specifications

1 - 4 Symbol DS9808 Product Reference Guide
3. Follow the steps for Installing the Interface Cable to connect a new cable.
Connecting Power (if required)
If the host does not provide power to the digital scanner, connect an external power supply:
1. Connect the interface cable to the base of the digital scanner, as described in Installing the Interface Cable on
page 1-3.
2. Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
3. Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into
an AC outlet.
Configuring the Digital Scanner
To configure the digital scanner use the bar codes included in this manual. See Chapter 4, User Preferences &
Miscellaneous Digital Scanner Options and Chapter 5, Imaging Preferences for information about programming the
digital scanner using bar code menus. Also see each host-specific chapter to set up connection to a specific host
type.
Mounting the Digital Scanner
An optional wall mount bracket is available for mounting the scanner to a wall or other vertical surface. To mount
the Symbol DS9808:
1. Place the bracket in its desired location on the wall, and insert three #6 screws through each screw hole in the
bracket.
Figure 1-4 Installing the Wall Mount Bracket
2. Tighten the screws to secure the bracket to the wall.