Specifications

Data Capture 2 - 5
Reading RFID Tags
Hands-Free RFID
The digital scanner is in hands-free mode when it sits on a countertop. In this mode, the digital scanner operates in
continuous (constant-on) mode by default, where it automatically reads RFID tags within the radio frequency (RF)
field of view.
Figure 2-2 RFID in Hands-Free Mode
The digital scanner beeps and the RFID LED momentarily turns off upon a tag read.
ADF Programming
Green Enter another digit. Add leading zeros to the front if necessary.
Enter another alphabetic character or scan the
End of Message bar code.
All criteria or actions cleared for current rule, continue entering rule.
Delete last saved rule. The current rule is left intact.
All rules deleted.
Blinking Green Enter another criterion or action, or scan the
Save Rule bar code.
Green after Blinking Rule saved. Rule entry mode exited.
Cancel rule entry. Rule entry mode exited because of an error or the user asked to exit
rule entry.
Red Out of rule memory. Erase some existing rules, then try to save rule again.
Entry error, wrong bar code scanned, or criteria/action list is too long for a rule. Re-enter
criterion or action.
Table 2-2 Standard LED Definitions
LED Indication
NOTE The top surface of the digital scanner base may feel slightly warm. This is normal and does not indicate a
problem.