Specifications

User Preferences 4 - 3
User Preferences Parameter Defaults
Table 4-1 lists defaults for user preferences parameters. There are two ways to change the default values:
• Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan *Restore Defaults on page 4-4.
• Download data through the device’s serial port using SSI. Hexadecimal parameter numbers appear in this
chapter below the parameter title, and options appear in parenthesis beneath the accompanying bar codes.
See the Simple Serial Interface (SSI) Programmer’s Guide for detailed instructions for changing parameters
using this method.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 4-1 User Preferences Default Table
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter Restore Defaults 4-4
Parameter Scanning ECh Enable 4-5
Beeper Tone 91h Medium 4-6
Beeper Volume 8Ch High 4-7
Power Mode 80h Continuous On 4-7
Time Delay to Low Power Mode 92h 5 Minutes 4-8
Trigger Mode 8Ah Auto Aim 4-9
Picklist Mode F0h 92h Disabled Always
Aim Dot only: Enabled Always
4-10
Decode Session Timeout 88h 9.9 Sec 4-11
Timeout Between Decodes, Same Symbol 89h 0.6 Sec 4-11
Beep After Good Decode 38h Enable 4-12
Fuzzy 1D Processing F1h, 02h Enable 4-12
Decode Mirror Images F1h, 19h Never 4-13
Scanstand Session Timeout F0h, 90h 2 Seconds 4-13