Specifications

Scanning 2 - 3
4 long low beeps Bad symbology. Scanned a 1D or 2D bar code in a MPDF sequence,
a duplicate MPDF label, a label in an incorrect order, or trying to
transmit an empty or illegal MPDF field.
5 long low beeps Flushing MPDF buffer.
Fast warble beep Aborting MPDF sequence.
Low/High beeps Flushing an already empty MPDF buffer.
ADF Programming: Normal Data Entry. Duration of tones are short.
High/Low beeps Enter another digit. Add leading zeros to the front if necessary.
Low/Low beeps Enter another alphabetic character or scan the
End of Message bar
code.
High/High beeps Enter another criterion or action, or scan the
Save Rule bar code.
High/Low/High/Low beeps Rule saved. Rule entry mode exited.
High/Low/Low beeps All criteria or actions cleared for current rule, continue entering rule.
Low beep Delete last saved rule. The current rule is left intact.
Low/High/High beeps All rules are deleted.
ADF Programming: Error Indications. Duration of tones are very long.
Low/High/Low/High beeps Out of rule memory. Erase some existing rules, then try to save rule
again. (It is not necessary to re-enter the current rule.)
Low/High/Low beeps Cancel rule entry. Rule entry mode exited because of an error or the
user asked to exit rule entry.
Low/High beeps Entry error, wrong bar code scanned. Re-enter criterion or action. All
previously entered criteria and actions are retained. Criteria or action
list is too long for a rule.
Host Specific
USB only
4 short high beeps Digital scanner did not complete initialization. Wait several seconds
and scan again.
Short low/short medium/short high
beep sequence after scanning a USB
device type
Communication with the bus must be established before the digital
scanner can operate at the highest power level.
Short low/short medium/short high
beep sequence occurs more than once
The USB bus can put the digital scanner in a state where power to
the digital scanner is cycled on and off more than once. This is
normal and usually happens when the PC cold boots.
RS-232 only
1 short high beep A <BEL> character is received and Beep on <BEL> is enabled.
Table 2-1 Beeper Definitions (Continued)
Beeper Sequence Indication