Specifications

Scanner Emulation Interface 12 - 3
If a power supply is used, disconnect the power supply before changing host cables or the cradle may not
recognize the new host.
Scanner Emulation Parameter Defaults
Table 12-1 lists the defaults for the Scanner Emulation host. To change any option, scan the appropriate bar
code(s) provided in the Scanner Emulation Host Parameters section beginning on page 12-4.
Scanner Emulation Host
Scan the bar code below to enable the Scanner Emulation host.
CAUTION Connect the cradle to a 5 volt decoder only. Connecting the cradle to a 12 volt decoder can damage
the digital scanner and invalidate the warranty.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 12-1 Scanner Emulation Default Table
Parameter Default Page Number
Beep Style Beep on Successful Transmit 12-4
Parameter Pass-Through Parameter Process and Pass Through 12-5
Convert Newer Code Types Convert Newer Code Types 12-6
Module Width 20 µs 12-6
Convert All Bar Codes to Code 39 Do Not Convert Bar Codes to Code 39 12-7
Code 39 Full ASCII Conversion Disable 12-7
Transmission Timeout 3 sec 12-8
Ignore Unknown Characters Ignore Unknown Characters 12-9
Leading Margin 2 ms 12-9
Check for Decode LED Check for Decode LED 12-10
1
User selection is required to configure this interface and this is the most common selection.
Undecoded Scanner Emulation Host