user manual

Mesh Enabled Architecture Geo-Location Reference Guide
7
Alert Window
The Alert Window displays certain events that may occur while the system is operating. These
events are summarized by Event Time, MAC Address, Name, and the Status.
You can choose to either enable or disable display this window by selecting the Alert
Window option under the Window menu.
Figure 9. Alert Window
Alert Parameter Description
Event Time The date and time stamp for when the event that triggered the
alert was captured.
MAC Address The MAC address for the device being monitored.
Name The name of the network node being monitored. The name
displayed here will vary depending on the display attributes
selected. The default display parameter is the MAC address
formatted to remove hyphenation.
Status The current status of the sensor device. One of the following
Alert Status messages will be displayed:
New Sensor Detected – Additional configuration parameters
have been applied and a sensor has been detected and added
to the network configuration. The device name will migrate
from the Unconfigured Sensors folder to the appropriate
network configuration folder in the Sensor ID Window.
Sensor is On-Line – A sensor device that is currently
configured in the network is on-line.
Sensor is Off-Line – A sensor device that is currently
configured in the network is off-line.
Sensor is Dead – Communications cannot be established with
a sensor device that is currently configured in the network.