User`s manual

8
Getting started
Belt clip & optional headset
Install belt clip as shown below, if desired.
For handsfree headset conversations, use any industry standard
2.5 mm headset (purchased separately). For best results, use an
AT&T 2.5 mm headset. To purchase a headset, visit our website at
www.telephones.att.com or call 1 [phone]. In
Canada, dial 1 [phone].
Plug a 2.5 mm
headset into the
jack on the side of
the handset.
Lift the rubber
flap here.
Side of the
handset
To attach the belt
clip:
Snap the belt clip into the
retaining tabs on both
sides of the handset as
shown in the figure.
To remove the belt clip:
Gently lift either of the belt clip
retaining tabs, shown in the
figure, outwards to remove the
belt clip from the handset.