A TM THE UNION OF PAGING AND CELLULAR TECHNOLOGIES User’s Guide 1
INTRODUCTION Your RSVP Numeric Display Pager turns any Motorola MicroTAC™ or retail pocket personal cellular telephone into the ultimate personal communicator. RSVP also features a removable and rechargeable, ultra-thin, Nickel-MetalHydride cellular battery. RSVP slides onto the back of your phone in place of the existing battery unit, providing the control and convenience of a pager and a phone in a single unit.
PROCEDURE FOR CONNECTING YOUR NEW RSVP PAGER TO YOUR CELLULAR PHONE Remove battery from any Motorola MicroTAC or retail pocket personal cellular telephone in the following manner: ② ① Press and hold down battery release Slide battery downward against stop t t ③ Lift battery off cellular phone t 3
Note: Ensure the Nickel-Metal-Hydride battery is fully charged and installed in the RSVP pager before performing this procedure. Install your RSVP pager in place of the cellular phone battery in the following manner: ① Position RSVP with display end toward phone antenna RSVP ② Set onto mounting slide approximately one inch below battery release ③ Slide RSVP up until pager snaps into place PAGING SERVICE ACTIVATION Paging service providers require certain procedures for activating your RSVP pager.
CONTROLS AND DISPLAY INDICATORS The locations and descriptions of the RSVP pager controls and display indicators are shown below: Display Alert/Backlight Indicator Backlight/Reset Button (●) On/Read/ Select Button (W) Menu/Lock Button (X) Battery Charger/ Programmer Contacts Pager Display: Message Lock Indicator Alarm Indicator \ [ Alert Mode Indicator = B Time of Day 1: Message Slot Number 10:47a Continuing Message Indicator 12:48p Message Time Stamp 5
TURNING YOUR PAGER ON Press W to turn your pager on. Your pager will alert indicating that it is on. The time of day and the “Alert Mode” indicator, silent ([) or audible (D), is displayed. READING MESSAGES The RSVP pager can receive up to eight 20-character messages. When a message is received, the pager alerts with an audible or a vibrate alert, and a flashing alert indication. Press any button to stop the alert. Display your message as follows: 1. Press the W button to display your message.
CHANGING ALERT MODES 1. Press X. Either “Silent?” or “Audio?” is displayed, depending on the current mode. 2. To change the alert mode, press W. For your pager to vibrate, it must be in the “silent” mode. TURNING YOUR PAGER OFF 1. Press X until the “PAGER OFF?” prompt is displayed. 2. Press W to turn the pager off. With the pager off, the clock is shown on the display, but not the “Alert Mode” indicator. SETTING THE ALARM Your pager’s alarm can be set to alert you to a certain time of day.
LOCKING AND UNLOCKING MESSAGES Locked messages cannot be erased or overwritten by new messages when memory is full. Also, they are not lost while replacing the battery. Up to four messages may be locked at one time. Lock your messages as follows: L 1. Press X while reading your message. A lock ( ) appears on the display to indicate your message is protected. 2. To unlock your message, press X while reading the locked message. ERASING MESSAGES FROM MEMORY 1.
BATTERY REPLACEMENT Remove RSVP from your cellular telephone and replace the RSVP battery as shown below: ① Press release then slide pager downward away from antenna ② Lift pager away from cellular pager over, ③ Turn insert tip of ball pen under release and pry up on release, then lift battery out of pager Release Install your new battery in the reverse order of removal.
CHARGING YOUR BATTERY Your battery may be charged while attached to your cellular phone or separately using the optional adapter shown in the following illustration: Cellular phone with RSVP and battery or RSVP with battery Place battery into adapter and insert into charger RSVP battery Adapter Charger has two charging locations Refer to the charger manufacturer’s instructions for specific use of your charger.
CLEANING YOUR RSVP PAGER To clean smudges and grime from the exterior of your RSVP pager as well as your cellular phone, use a soft, non-abrasive cloth moistened in a mild soap and water solution. Rinse the surface using a second cloth moistened in clean water. Do not use alcohol or other cleaning solutions. REPAIR AND MAINTENANCE Your RSVP pager properly handled is capable of many years of trouble-free service.
© Copyright 1995, Motorola, Inc. All Rights Reserved. Motorola Derivative Technologies Division, 3301 Quantum Blvd., Boynton Beach, FL 33426, Printed in U.S.A. 10/95, t, Motorola, MicroTAC, and RSVP are trademarks or registered trademarks of Motorola, Inc.
