user manual

10-48 Administrator’s Handbook
Once you make the selection, if you factory Default the Router, it will reboot with the saved configuration you
have selected.
To remove the saved configuration from being the Factory Default, select Remove Factory Default
Configuration and press Return. This will remove the configuration from being used as the Factory Default.
It does not, however, delete the configuration, so you can still re-use it at any time.
TFTP
You can also send or receive your stored configuration files via TFTP. You select the stored configuration files
from pop-up menus in the TFTP File Transfer screen in the Utilities & Diagnostics menu, as shown.
Configuration Management
Save Current Configuration as...
Replace Existing Configuration...
Boot from a Configuration...
Delete a Configuration...
Factory Default from Configuration: HappyInternet
Remove Factory Default Configuration
Return/Enter to select Factory Default Configuration.
Trivial File Transfer Protocol (TFTP)
TFTP Server Name:
Firmware File Name:
GET ROUTER FIRMWARE FROM SERVER...
Config File Name: +-----------------------+
+-----------------------+
Get Configuration Destination... | Current Configuration |
GET CONFIG FROM SERVER... | Backup Config |
| HappyInternet |
Send Configuration... | <Empty> Type Name |
SEND CONFIG TO SERVER... +-----------------------+
TFTP Transfer State -- Idle
TFTP Current Transfer Bytes -- 0
Up/Down Arrow Keys to select, ESC to dismiss, Return/Enter to Edit.