user manual

WAN Conﬁguration 2-3

• 100 Mbps Full Duplex

• 100 Mbps Half Duplex

• 10 Mbps Full Duplex

• 10 Mbps Half Duplex

• 100 Mbps, Full Duplex, Fixed

• 100 Mbps, Half Duplex, Fixed

• 10 Mbps, Full Duplex, Fixed

• 10 Mbps, Half Duplex, Fixed

This may be useful in mixed networks, where multiple routers have different ethernet speed capability. If

you want to maintain a single speed setting for compatibility with multiple routers on your LAN, you can

select a speed/duplex combination that all of your routers can match.

• The Wan Ethernet MAC Address is the hardware address of the Motorola Netopia

device. Some service

providers require a speciﬁc MAC address as part of their authentication process. In such a case, you can

enter the MAC address that your service provider requires. If your service provider doesn’t use this

method, you don’t need to change this ﬁeld.

• The DHCP Client Mode setting depends on the type of access concentrator equipment your service

provider uses. Most use Standards-Based. Alternatively, your provider may instruct you to select Copper

Mountain Speciﬁc.

• The RIP Options selection displays the WAN Ethernet RIP Parameters screen.

• The Receive RIP pop-up menu controls the reception and transmission of Routing Information Protocol

(RIP) packets on the Ethernet WAN port. The default is Both.

WAN Ethernet RIP Parameters

+----------------+

Receive RIP: | Off |

| v1 |

| v2 |

| Both v1 and v2 |

| v2 MD5 Authentication

+----------------+