User manual

Overview
2-52
2.2.19 redundancy-group
Common to all modes
Syntax
show redundancy-group [config|runtime]
Parameters
Example
RFS7000(config)#show redundancy-group config
Redundancy Group Configuration Detail
Redundancy Feature : Disabled
Redundancy group ID : 1
Redundancy Mode : Primary
Redundancy Interface IP : 0.0.0.0
Number of configured peer(s) : 0
Heartbeat-period : 5 Seconds
Hold-period : 15 Seconds
Discovery-period : 30 Seconds
Handle STP : Disabled
Switch Installed License : 0
Switch running image version : 1.0.0.0-228D
RFS7000(config)#
RFS7000>show redundancy-group runtime
Redundancy Group Runtime Information
Redundancy Protocol Version : 2.0
Redundancy Group License : 0
Cluster AP Adoption Count : Not Applicable
Switch AP Adoption Count : Not Applicable
Redundancy State : Disabled
Radio Portals adopted by Group : Not Applicable
Radio Portals adopted by this Switch : Not Applicable
Rogue APs detected in this Group : Not Applicable
Rogue APs detected by this Switch : Not Applicable
MUs associated in this Group : Not Applicable
MUs associated in this Switch : Not Applicable
Radios in selfhealing mode : Not Applicable
Selfhealing APs in this Switch : Not Applicable
Group maximum AP adoption capacity : Not Applicable
Switch Adoption capacity : Not Applicable
Established Peer(s) Count : Not Applicable
Redundancy Group Connectivity status : Not Applicable
RFS7000>
RFS7000(config)#show redundancy-group
Redundancy Group Configuration Detail
Redundancy Feature : Disabled
Redundancy group ID : 1
Redundancy Mode : Primary
Redundancy Interface IP : 0.0.0.0
Number of configured peer(s) : 0
Heartbeat-period : 5 Seconds
Hold-period : 15 Seconds
Discovery-period : 30 Seconds
Handle STP : Disabled
Switch Installed License : 0
Switch running image version : 1.0.0.0-228D
config Displays redundancy group information.
runtime Displays runtime redundancy group information.