User manual

2-25
2.2 show

Common Commands
This command displays the settings for the specified system component. There are a number of ways to invoke
the show command:
• Invoked without any arguments, show displays information about the current context. If the current
context contains instances, then show command (usually) displays a list of these instances.
• Invoked with the display_parameter, it displays information about that component.
Syntax
show [display_parameter]
Parameters
Display
Parameters
Description Mode Example
autoinstall Displays the autoinstall configuration. Common page 2-28
banner Displays “Message of the Day” login banner. Common page 2-29
commands Displays a command lists. Common page 2-30
debugging Debugs information outputs. Common page 2-32
environment Displays environmental information. Common page 2-34
history Displays the session command history. Common page 2-34
interfaces Displays interface status and configuration. Common page 2-35
ip Displays the Internet Protocol. Common page 2-37
ldap Displays LDAP server configuration
parameters.
Common page 2-41
licenses Displays installed licenses, if any. Common page 2-42
logging Displays the log configuration and buffer. Common page 2-43
mac Displays the media access control IP
configuration.
Common page 2-44
mac-address-table Display the MAC address table Common page 2-45
management Displays the L3 management interface name. Common page 2-46
mobility Displays mobility parameters. Common page 2-47
ntp Displays the network time protocol. Common page 2-49
privilege Displays the current privilege level. Common page 2-50
radius Displays RADIUS configuration commands. Common page 2-51
redundancy-group Displays redundancy group parameters. Common page 2-52