User manual

14-35
14.1.26 sensor
Wireless Configuration Commands
Use this command to configure Wireless Intrusion Protection System parameters.
Syntax
sensor(default-config|vlan)
sensor default-config(ip-mode|wips-server-ip)
sensor default-config ip-mode(dhcp|static(A.B.C.D/M)(A.B.C.D))
sensor default-config wips-server-ip(primary|secondary)(A.B.C.D)
Parameters
Example
RFS7000(config-wireless)#sensor vlan 268 500
RFS7000(config-wireless)#
default-config
Default configuration sent to sensors when configured.
ip-mode
Configures the IP address mode of the sensors.
• dhcp – Sensors must use DHCP to obtain an IP address.
• static (A.B.C.D/M)(A.B.C.D) – Sensors must use the specific static IP
address.
• A.B.C.D/M – Sensor IP address and network mask.
• A.B.C.D – Specifies the gateway IP address for sensors.
wips-server-ip
Specifies the IP addresses of the WIPS server.
• primary (A.B.C.D) – Specifies the primary IP address of the WIPS Server.
• secondary (A.B.C.D) – Specifies the secondary IP address of the WIPS
Server.
vlan<1-4094>
Configures VLANs where sensors are to be discovered.