User manual

Overview
2-16
Parameters (Priv Exec mode only)
clear
[all|aplogs|clitree|cores|
dumps|panics|
pm (statistics|sys-restart-
count)|
securitymgr (flows)
[<0-349>|WORD|
all|fe|ge|sa|tunnel|vlan]]
Resets different functions.
• all – Removes all core, dump and panic files.
• aplogs – Removes all ap log files.
• clitree – Removes clitree.html (created by the save-cli command).
• cores – Removes all core files.
• dumps – Removes all dump files.
• panics – Removes all kernel panic files.
• pm (statistics|sys-restart-count) – Process Monitor.
• securitymgr (flows) [<0-349>|WORD| all|fe|ge|sa|tunnel|vlan]] –
Securitymgr parameters.
copy (tech-support)
[FILE|URL]
Copies from one file to another.
• tech-support – Copies extensive system information useful to technical
support for troubleshooting.
• FILE – Target file to copy.
• URL – Target URL to copy.
diag [enable|identify|limit|
period|watchdog]
Use this parameter as a diagnostics tool.
• enable – Enables service diagnostics.
• identify – Identifies this switch by flashing the LEDs.
• limit – Diagnostic limit command.
• buffer (128|128k|16k|1k|256|2k|32|32k|4k|512|64|64k|8k) <0-65535>
– Buffer usage warning limit.
• fan <1-3> – Fan speed limit of the fan number.
• filesys (etc2|flash|var) – File system freespace limit.
• inodes (etc2|flash|var) – File system inode limit.
• load (1|15|5) – Agregate processor load during the previous minutes,
based on the option selected.
• maxFDs <0-32767> – Maximum number of file descriptors.
• pkbuffers <0-65535> – Packet buffer head cache.
• procRAM <0.0-100.0> – Percent RAM used by a process.
• ram <0.0-25.0> – Percent free RAM.
• routecache <0-65535> – IP route cache usage.
• temperature <1-8> (critical|high|low) – Temperature limit.
• period <100-30000> – Set diagnostics period. The default period is set as
1000 milliseconds.
• watchdog – Enable the watchdog.