User manual

Overview
14-2
dhcp-sniff-state Record mobile unit DHCP state information. page 14-10
dot11-shared-key-auth Enables support for 802.11 shared key authentication. page 14-11
end Ends the current mode and moves to the EXEC mode. page 14-12
exit Ends the current mode and moves to the previous mode. page 14-13
fix-windows-dhcp Converts Windows DHCP Server responses to
Unicast instead
of
Broadcast.
page 14-14
help Describes the interactive help system. page 14-15
ids Intrusion detection configuration commands. page 14-16
mac-auth-local Local MAC authentication list. page 14-18
manual-wlan-mapping Allows manual mapping/un-mapping of WLANs to configured
radios.
page 14-19
mobile-unit Configures mobile unit related parameters. page 14-20
mobility Configures mobility parameters. page 14-21
multicast-packet-limit Sets a multicast packet limit per second for VLAN. page 14-22
no Negates a command or set its defaults. page 14-23
oversized-frames Attempts to use oversized frames for data traffic. page 14-24
proxy-arp Responds to ARP requests on behalf of mobile units. page 14-25
qos-mapping QoS mappings between the wired and wireless domains. page 14-26
radio Radio related commands. page 14-27
self-heal Self healing configuration commands. page 14-33
sensor Wireless Intrusion Protection System (WIPS) parameters. page 14-35
service Service commands. page 14-36
show Shows running system information. page 14-38
smart-scan-channels Specifies a list of channels used on the network. This list is
provided to mobile units that support partial scanning.
page 14-40
wlan Wireless LAN related commands. page 14-41
Command Description Ref.