User manual

Wireless Instance
Use the (config-wireless)instance to configure wireless parameters.
14.1 Wireless Configuration Commands
Table 14.1 summarizes the Global Config commands.
Table 14.1 Wireless Configuration Command Summary
Command Description Ref.
adopt-unconf-radio Adopts a radio even if not configured. The default templates is
used for configuration.
page 14-3
adoption-pref-id Defines spreference identifier for the switch. All radios
configured with this preference identifier are more likely to be
adopted by this switch.
page 14-4
ap-detection Access port detection configuration commands. page 14-5
broadcast-tx-speed Sets the rate at which broadcast and multicast traffic must be
transmitted.
page 14-6
clrscr Clears the display screen. page 14-7
convert-ap Changes the mode of operation of an access port. page 14-8
country-code Configures the country of operation. Regulatory configuration
(channels, self healing offset) of all configured radios is reset
to default values.
page 14-9