User manual

Overview
2-12
2.1.5 no
Common Commands
Use this command to either negate a command or set its defaults.
Syntax
no
Parameters
None.
Example
RFS7000(config)#no ?
access-list Internet Protocol (IP)
autoinstall autoinstall configuration command
banner Reset login banner to nothing
bridge Bridge group commands
country-code Clear the currently configured country code. All existing
radio configuration will be erased
crypto Encryption related commands
debug Debugging functions
ftp Configure FTP Server
hostname Reset system's network name to default
interface Delete a virtual interface
ip Internet Protocol (IP)
line Configure a terminal line
logging Modify message logging facilities
management sets properties of the management interface
ntp Configure NTP
prompt Reset system's prompt
radius-server RADIUS server configuration commands
redundancy Configure redundancy group parameters
service Service Commands
snmp-server Modify SNMP engine parameters
timezone Revert the timezone to default (UTC)
username Establish User Name Authentication
wlan-acl Remove an ACL from a WLAN port
RFS7000(config)#no bridge multiple-spanning-tree
RFS7000(config)#
RFS7000(config)#no bridge instance <1-15> priority
RFS7000(config)#
RFS7000(config)#no bridge forward-time
RFS7000(config)#
RFS7000(config)#no bridge hello-time
RFS7000(config)#
RFS7000(config)#no bridge max-age
RFS7000(config)#
RFS7000(config)#no bridge max-age
RFS7000(config)#
RFS7000(config)#no bridge spanning-tree portfast bpdu-filter
RFS7000(config)#
RFS7000(config)#no bridge spanning-tree portfast bpduuard
RFS7000(config)#
RFS7000(config)#no bridge spanning-tree errdisable-timeout enable
RFS7000(config)#
RFS7000(config)#no bridge spanning-tree errdisable-timeout interval
RFS7000(config)#