User manual

Overview
12-16
12.1.14 host
DHCP Config Commands
Use this command to configure a fixed IP address for the host in dotted decimal format. Use the no host
command to remove the host from the DHCP pool.
Syntax
host <IP address>
Parameters
Usage Guidelines
The DHCP host pool (used to manually assign specify IP address based on hardware address/client identifier),
configuration must contain a host IP address, client name and hardware address/client identifier.
The host IP address must belong to any subnet that exisits on the switch. There must be a DHCP network pool
corresponding to that host IP address. There is no limit on the number of manual bindings but you can configure
only one manual binding per host pool.
Example
RFS7000(config-dhcp)#host 2.2.2.111
RFS7000(config-dhcp)#
host <IP address> Fixed address for host.
• IP address – IP address in dotted decimal format.