User manual

Standard ACL Instance
Use the (config-std-nacl) instance to configure ip access-list standard ACLs. Standard ACLs
allow filtering based on the source address only.
10.1 Standard ACL Config Commands
Table 10.1 summarizes config-std-nacl commands.
Table 10.1 Extended ACL Config Command Summary
Command Description Ref.
clrscr Clears the display screen. page 10-2
deny Specifies packets to reject. page 10-3
end Ends the current mode and change to EXEC mode. page 10-4
exit Ends the current mode and moved back to the previous mode. page 10-5
help The interactive help system. page 10-6
mark Specifies packets to mark. page 10-7
no Negates a command or set its defaults. page 10-8
permit Specifies packets to forward. page 10-9
service Service commands. page 10-10
show Shows the running system information. page 10-11
terminal Sets terminal line parameters. page 10-13