User manual

interface Instance
Use the (config-if) instance to configure Fast Ethernet (fe), Giga Ehternet (ge), StaticAggregate interface
(sa), VLAN and tunnel . Use the
(config)# interface [fe|ge|sa|tunnel|vlan] to reach this instance.
7.1 Interface Config commands
Table 7.1 summarizes the config-if commands.
Table 7.1 Interface Config Command Summary
Command Description Ref.
clrscr Clears the display screen. page 7-3
description Interface specific description. page 7-4
duplex Sets the duplex to interface. page 7-5
end Ends the current mode and moves to the EXEC mode. page 7-6
exit Ends the current mode and moves down to the previous mode. page 7-7
help Describes the interactive help system. page 7-8
ip Internet Protocol (IP). page 7-9
mac MAC interface commands. page 7-11
management Sets the selected interface as the management interface. page 7-12
mtu Sets the mtu value for the VLAN interface. page 7-13
no Negates a command or sets defaults. page 7-14