User manual

5-41
5.1.25 redundancy
Global Configuration Commands
Use this command to configure redundancy group parameters.
Syntax
redundancy(discovery-period|enable|group-id|handle-stp|
heartbeat-period|hold-period|interface-ip|manual-revert|member-ip|mode)
redundancy discovery-period <10-60>
redundancy enable
redundancy group-id <1-65535>
redundancy handle-stp(enable)
redundancy heartbeat-period
redundancy hold-period <10-255>
redundancy interface-ip(A.B.C.D)
redundancy member-ip (A.B.C.D)
redundancy mode(primary|standby)
Parameters
discovery-period Sets the redundancy discovery interval.
<10-60> Discovery time in secs (default is 30).
enable Enables the redundancy protocol.
group-id Sets the redundancy group Id.
<1-65535> Redundancy group Id.
handle-stp Delays the redundancy protocol state machine exec, considering STP.
enable Sets handle-stp value as true.
heartbeat-period Sets the redundancy heartbeat interval.The
heartbeat-period must always
be less than the
hold-period.
<1-255> Heartbeat interval in secs (default is 5).
hold-period Sets the redundancy hold interval.
<10-255> Hold interval in secs (default is 15).
interface-ip Sets redundancy interface IP address.
A.B.C.D IP address of the switch.
manual-revert Reverts standby to non-active mode.
member-ip Add member to this redundancy group.
A.B.C.D IP address of the member.
mode Sets the redundancy mode.
primary Defines mode as primary.
standby Defines mode as standby.