Installation guide

Network Setup
4-8
2. In the Destination Subnet field, enter an IP address to route packets to a specific destination
address.
3. Enter a subnet mask for the destination subnet in the Subnet Mask field.
The Subnet Mask is the IP mask used to divide internet addresses into blocks known as subnets. A
value of 255.255.255.0 support 256 IP addresses.
4. In the Gateway Address field, enter the IP address of the gateway used to route the packets to the
specified destination subnet. Do not set the gateway address to a VLAN interface used by the switch.
5. Refer to the Status field for the current state of the requests made from applet. This field displays
error messages if something goes wrong in the transaction between the applet and the switch.
6. Click OK to use the changes to the running configuration and close the dialog.
7. Click Cancel to close the dialog without committing updates to the running configuration.
4.2.3 Viewing Address Resolution
The Address Resolution table displays the mapping of layer three (IP) addresses to layer two (MAC)
addresses. To view address resolution details:
1. Select Network > Internet Protocol from the main tree menu.
2. Select the Address Resolution tab.
3. Refer to the Address Resolution table for the following information:
Interface Displays the name of the actual interface where the IP address was
found (typically a VLAN).
IP Address Displays the IP address being resolved.
MAC Address Displays the MAC address corresponding to the IP address being
resolved.
Type Defines whether the entry was added statically or created
dynamically in respect to network traffic. Entries are typically
static.