Installation guide

Switch Information
3-31
2. Refer to the Switch Configuration field to enable and define the configuration for automatic
configuration file updates. If enabled, the located (updated) configuration file will be used with the
switch the next time the switch boots
3. Refer to the Redundancy Configuration field to enable and define the configuration for automatic
cluster file updates.
Enable Select the Enable checkbox to allow an automatic configuration
file update when a newer (updated) file is detected (upon the boot
of the switch) at the specified IP address.
IP Address Define the IP address of the server where the configuration files
reside. If a new version is detected when the switch is booted, it is
uploaded to the switch and used upon the next boot of the switch.
User ID Enter the User ID required to access the FTP or HTTP server.
Password Enter the Password for the User ID required to access the FTP or
HTTP server.
File Name (With Path) Provide the complete and accurate path to the location of the
configuration files on the server. This path must be accurate to
ensure the most recent file is retrieved.
Protocol/Device Use the Protocol drop-down menu to specify the Unset, FTP,
TFTP, HTTP, FLASH, CF, USB1, or USB2 as the medium used for
the file update from the server. The switch’s resident flash is
selected by default.
Password Enter the password required to access the server.
Enable Select the Enable checkbox to allow an automatic cluster file
update when a new (updated) file is detected (upon the boot of the
switch) at the specified IP address.
IP Address Define the IP address of the server where the cluster files reside.
If a new version is detected when the switch is booted it will be
uploaded to the switch and used upon the next boot of the switch.
User ID Enter the User ID required to access the FTP or HTTP server.
Password Enter the Password for the User ID required to access the FTP or
HTTP server.
File Name (With Path) Provide the complete and accurate path to the location of the
cluster files on the server. This path must be accurate to ensure the
most recent file is retrieved.
Protocol/Device Use the Protocol drop-down menu to specify Unset, FTP, TFTP,
HTTP, FLASH, CF, USB1, or USB2 as the medium used for the file
update from the server. The switch’s resident flash is selected by
default.
Password Enter the password required to access the server.