Installation guide

Switch Management
7-7
2. Select an existing Community Name from those listed and click the Edit button.
3. Modify the Community Name used to associate a site-appropriate name for the community. The
name revised from the original entry is required to match the name used within the remote network
management software.
4. Modify the existing read-only (R) access or read/write (RW) access for the community. Read-only
access allows a remote device to retrieve information, while read/write access allows a remote
device to modify settings.
5. Click OK to save and add the changes to the running configuration and close the dialog.
6. Refer to the Status field for the current state of the requests made from applet. This field displays
error messages if something goes wrong in the transaction between the applet and the switch
7. Click Cancel to return back to the SNMP v1/v2 screen without implementing changes.
7.3.2 Configuring SNMP v3 Access
SNMP Version 3 (SNMPv3) adds security and remote configuration capabilities to previous versions. The
SNMPv3 architecture introduces the User-based Security Model (USM) for message security and the View-
based Access Control Model (VACM) for access control. The architecture supports the concurrent use of
different security, access control, and message processing techniques.
Refer to the v3 screen to review the current SNMP v3 configuration. An Existing User Name can be selected
and edited, enabled or disabled. .
To review existing SNMP v3 definitions:
1. Select Management Access > SNMP Access from the main menu tree.
NOTE The SNMP undo feature is not supported in this product.
CAUTION The RFS7000 switch uses 3 unique (default) SNMPv3 user names and
passwords for MD5 authentication and DES privacy.
username = snmpoperator/password = operator
username = snmpmanager/password = symboladmin
username = snmptrap/password = symboladmin
!