Installation guide

Switch Management
7-6
1. Select Management Access > SNMP Access > v1/v2 from the main menu tree.
2. Refer to the Community Name and Access Control parameters for the following information:
3. Highlight an existing entry and click the Edit button to modify the properties of an existing SNMP V1/
v2 community and access control definition. For more information, see Editing an Existing SNMP v1/
v2 Community Name on page 7-6.
7.3.1.1 Editing an Existing SNMP v1/v2 Community Name
The Edit screen allows the user to modify a community name and change its read-only or read/write
designation. Since the community name is required to match the name used within the remote network
management software, it is recommended the name be changed appropriately to match a new naming (and
user) requirement used by the management software.
To modify an existing SNMP v1/v2 Community Name and Access Control setting:
1. Select Management Access > SNMP Access > v1/v2 from the main menu tree.
Community Name Displays the read-only or read-write name used to associate a site-
appropriate name for the community. The name is required to
match the name used within the remote network management
software. Click the Edit button to modify an existing Community
Name.
Access Control The Access Control field specifies a read-only (R) access or read/
write (RW) access for the community. Read-only access allows a
remote device to retrieve information, while read/write access
allows a remote device to modify settings. Click the Edit button to
modify an existing Access Control permission.